|
Table of Contents
fpit - Fujitsu Stylistic input driver
Section "InputDevice"
Identifier "idevname"
Driver "fpit"
Option "Device" "devpath"
...
EndSection
fpit is an XFree86 input driver for Fujitsu Stylistic Tablet
PCs.
The fpit driver functions as a pointer input device, and may be used
as the X server's core pointer.
This driver supports the
touchscreen of the Stylistic LT and (with special options) of the Stylistic
500, 1000 and 2300.
Under Linux the Fujitsus serial port is not, by default,
detected. Therefore the following must be added to one of your start-up scripts.
(Either one of the X scripts, or to rc.local or similar).
- setserial /dev/ttyS3
autoconfig
- setserial /dev/ttyS3 IRQ 15 baud_base 115200 port 0xfce8
-
Please refer to XF86Config(5x)
for general configuration details
and for options that can be used with all input drivers. This section only
covers configuration details specific to this driver.
The device supports
the following options:
- Option "MaximumXPosition" "number"
- Sets the maximum
X position, use this to callibrate your touchscreen's right hand edge.
- Option
"MinimumXPosition" "number"
- Sets the minimum X position, use this to callibrate
your touchscreen's left hand edge.
- Option "MaximumYPosition" "number"
- Option
"MinimumYPosition" "number"
- Same as for X axis, but for Y axis.
- Option "InvertX"
- Option "InvertY"
- Invert the specified axis.
- Option "SwapXY"
- Swap the X and
Y axis.
- Option "Rotate" "CW"
- Option "Rotate" "CWW" Manipulate the invert
and swap options to match screen rotations.
- Option "DeviceName" "name"
- Option
"DeviceName" "name" sets the name of the X device.
- Option "AlwaysCore" "on"
- enables the sharing of the core pointer. When this feature is enabled, the
device will take control of the core pointer (and thus will emit core events)
and at the same time will be able, when asked so, to report extended events.
You can use the last available integer feedback to control this feature.
When the value of the feedback is zero, the feature is disabled. The feature
is enabled for any other value.
- Option "DebugLevel" number
- sets the level
of debugging info reported.
- Option "BaudRate" "38400", "19200" or "9600"
(default)
- changes the serial link speed.
Example, for Stylistic LT setup
is:
Section "InputDevice"
Identifier "mouse0"
Driver "fpit"
Option "Device" "/dev/ttyS3"
EndSection
And for other Stylistic devices try:
Section "InputDevice"
Identifier "mouse0"
Driver "fpit"
Option "Device" "/dev/ttyS3"
Option "BaudRate" "19200"
Option "MaximumXPosition" "6250"
Option "MaximumYPosition" "4950"
Option "MinimumXPosition" "130"
Option "MinimumYPosition" "0"
Option "InvertY"
EndSection
XFree86(1)
, XF86Config(5)
, xf86config(1)
, Xserver(1)
, X(7)
.
Original
FPIT port: Rob Tsuk <rob@tsuk.com> and John Apfelbaum <johnapf@linuxslate.com>
X4 Port: Richard Miller-Smith <richard.miller-smith@philips.com>, based on Elographics
code from: Patrick Lecoanet
X4.2 Cleanup: Alan Cox
Table of Contents
|
